2006 Scion tC
Mileage
184,781
Service Date
12/13/2024
Services Performed
- Test drive to confirm customer complaint: Remove four wheels to inspect brake condition. Inspect entire system for leaks. Document amount of lining remaining is approximately: Front- 5mm Rear- 1mm Rotor Thickness: Front Left – .954 Front Right – .951 Front Rotor Minimum Machining Spec- .906 Rear Left – .337 Rear Right – .326 Rear Rotor Minimum Machining Spec- .295 Rear brake pads are low and rotors are too close to minimum machining specification. Front rotors are glazed.
- Test drive for any suspension noise. Check and inspect suspension components: ball joints, tie rods, idler arms, springs, bushings, and check for accident damage, check for any excessive play in steering. Check shocks or struts for proper operation. Lower control arm bushings are stretched out and will tear soon. Tie rod end boots torn but have no play at this time. All 4 struts have no support when going over speed bumps or hitting dips. Both axles starting to sling grease. Oil pan seeping. Check engine light is on TPMS light is on Door ajar light is on, with all doors closed.
- Plug into diagnostic connector to retrieve computer fault codes. Test drive to confirm or Verified Customer Complaint. Document fault code Present:
- SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment.]
- SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include wheel alignment.]
- Replace front brake pads, resurface or replace both brake rotors, inspect clean & lube caliper mountings slides or pins. Bleed front brakes if needed. Road test when done.
- Replace rear disc brake pads, remove and resurface both rear brake rotors. Clean and lube caliper mounting or slide pins, make any needed adjustment and road test when done.
Michelle R. gave our service a 5 star review on 12/13/2024
